Khắc phục sụt áp ngắn hạn lưới phân phối 15 nút sử dụng D-STATCOM
Abstract
This paper presents mathematical model and system simulation using D-Statcom device to overcome the short-term voltage drop of the power system. Specifically, the parameters on the distribution network and the load are referred to at branch 371 of Kien Giang province. The branch has a total of 15 bus including the loads of companies and enterprises. The system is built and simulated in MATLAB/Simulink software. In case of three-phase short circuit for 1-1. 2s at bus 01. The simulation results show that the voltage at the buses is significantly improved when the system uses D-Statcom devices. Specifically, the voltage at the buses at the beginning, middle and end of the line have an amplitude of over 0.9 pa.
Tóm tắt
Bài báo trình bày mô hình toán và mô phỏng hệ thống sử dụng thiết bị D-Statcom để khắc phục sụt áp ngắn hạn hệ thống điện. Cụ thể, các thông số trên lưới phân phối và phụ tải được tham khảo tại nhánh 371 thuộc tỉnh Kiên Giang, nhánh có tổng cộng 15 nút bao gồm các phụ tải là các công ty, xí nghiệp. Hệ thống được xây dựng và mô phỏng trên phần mềm MATLAB/Simulink. Trường hợp ngắn mạch ba pha trong khoảng thời gian 1-1,2s tại nút 01. Kết quả mô phỏng cho thấy điện áp tại các nút được cải thiện rõ rệt khi hệ thống có sử dụng thiết bị D-Statcom. Cụ thể điện áp tại các nút ở đầu, giữa và cuối đường dây đều có biên độ trên 0,9pu.
Tài liệu tham khảo
[1]. IEEE Std. 1159-2009 (2009), “IEEE Recommended Practice for Monitoring Power
Quality", IEEE.
[2]. A. Ghosh, G. Ledwich (2002), "Power Quality Enhancement Using Custom Power
Devices", Kluwer Academic Publishers.
[3]. E. Acha, C. R. Fuerte-Esquivel, H. Ambriz-Perez, C. Angeles-Camacho (2014),
"FACTS Modelling and Simulation in Power networks", Wiley.
[4]. P Y. Pal, A. Swarup, B. Singh (2008), “A Review of Compensating Type Custom Power Devices for Power Quality Improvement: IEEE", Proceedings, 2008 Joint International Conference on Power System Technology and IEEE Power India Conference.
[5]. A. B. Kunya, T. Yalcinoz, and G. S. Shehu (2014), “Voltage sag and swell alleviation in distribution network using custom power devices; D-STATCOM and DVR", Proceedings, IEEE 16th International Power Electronics and Motion Control Conference and Exposition.
[6]. Math H. J. Bollen (2000), “Understanding Power Quality Problems: Voltage Sags
and Interruptions", IEEE Press.
[7]. J. J. Grainger, W. D. Stevenson (1994), "Power System Analysis" McGraw Hill.